Similar Articles

Browse Main Topics:

Business
Computers & Electronics
Education & Reference
Entertainment & Leisure
Family & Home
Finance & Investment
Health
Internet
Pets & Animals
Science & Technology
Society, Politics & Culture
Sports & Recreation

Similar Articles

U.S. CPSC July 17, 2008	All-Terrain Vehicles Recalled By American Honda Motor Co. Due to Risk of Loss of Control Hazard If the ATV's rubber CV (constant velocity) boots get punctured or torn the joint will become contaminated and severe binding of the CV joints could occur, resulting in the sudden loss of steering control. This poses a risk of injury or death to riders.
U.S. CPSC May 8, 2008	American Honda Motor Co. Recalls ATVs Due to Loss of Steering Control The electric power steering shaft of the recalled ATVs could break unexpectedly, resulting in the rider's losing steering control. This poses a risk of injury or death to riders.
U.S. CPSC July 28, 2005	American Suzuki Motor Corp. Recall of ATVs A significant impact to the front wheel of the ATV while the steering is fully turned to either side can result in suspension damage, wear, and an eventual loss of steering control that could result in injury or death.
U.S. CPSC December 14, 2005	American Honda Motor Corp. Recall of All-Terrain Vehicles A safety defect could exist in the transmission that could allow the rider to downshift from 1st gear into reverse without operating the reverse assist (lockout) lever. Unintended engagement of reverse gear while moving forward could lock the rear wheels and cause the rider to lose control.
U.S. CPSC July 24, 2006	American Suzuki Motor Corp. Recalls All-Terrain Vehicles The mounting brackets used to secure the left-front suspension arm to the ATV frame may not have been welded completely and could break off during riding. If this occurs the rider could lose control of the ATV and crash, posing a risk of serious injury or death.
U.S. CPSC January 9, 2008	ATVs Recalled By American Honda Motor Co. Due to Loss of Speed Control Water can enter the throttle position sensor and freeze, causing permanent damage if the rider forces the throttle lever. This could cause the throttle to stick open, posing a risk of injury or death to riders.
U.S. CPSC November 13, 2008	Off-Road Motorcycles Recalled by American Honda Motor Due to Risk of Swing Arm Weld Failure The weld on the right side of the swing arm can fail, causing the rider to lose control and crash. This could pose a risk of injury or death to riders.
U.S. CPSC December 8, 2005	Kawasaki Motors Corp. U.S.A. Recall of All-Terrain Vehicles Tie rod separation caused by either wear or severe impact can occur during operation, causing the front wheel to separate from the steering control. Separation of the tie rod can cause the rider to lose control of the ATV, resulting in a serious injury or death to the rider.
U.S. CPSC August 2, 2005	Kawasaki Motors Corp. U.S.A. Recall of ATVs A significant impact to the front wheel of the ATV while the steering is fully turned to either side can result in suspension damage, wear, and an eventual loss of steering control that could result in injury or death.
U.S. CPSC August 20, 2002	Arctic Cat Inc. Recalls All-Terrain Vehicles The ball joints on the front suspension of these ATVs can fail, resulting in a loss of control. This can cause the ATV to overturn, posing a risk of serious injury or death to riders.
U.S. CPSC December 22, 2009	Polaris Industries Recalls Certain ATVs Due to Crash Hazard The front suspension ball joint stem can separate from the steering knuckle and cause the rider to lose steering control, posing a risk of injury or death to riders.
U.S. CPSC March 20, 2007	American Suzuki Motor Corp. Recalls All-Terrain Vehicles The bushing pivot mount boss on the left and right suspension arm may not have been welded completely and could break off during riding. If this occurs, the rider could lose control of the ATV and crash, posing risk of serious injury or death.
U.S. CPSC June 21, 2006	American Suzuki Motor Corp. Recalls All-Terrain Vehicles for Crash Hazard If the cushion lever mounting bracket on the ATV frame breaks, the rider could lose control of the ATV and crash, posing a risk of serious injury or death.
U.S. CPSC October 7, 2003	Kawasaki Recall of ATVs The lower front suspension arm can separate from the steering assembly, resulting in a loss of steering control and posing a serious risk of injury to the rider.
U.S. CPSC May 30, 2007	Polaris Recalls Select Hawkeye Model ATVs Due to Loss of Control Hazard -- Three Crashes Reported The ATV's front bearing carrier can fail due to an insufficient amount of material thickness in the area where the lower a-arm and ball joint are attached which can result in a loss of control and a crash and/or serious injury to the operator.
U.S. CPSC December 29, 2010	American Honda Recalls Snowblowers Due to Fire Hazard The fuel tank joint and o-ring located on the underside of the fuel tank can seep or drip fuel over time, posing a fire hazard.
U.S. CPSC March 15, 2011	American Suzuki Motor Corp. Recalls QuadSport ATVs Due to Crash Hazard The regulator/rectifier circuit board can fail and cause the engine to stall during riding due to an insufficient battery charge, increasing the risk of a crash.
U.S. CPSC May 3, 2007	Stateside Powersports Recalls to Repair 90cc Youth Model ATVs The ATVs lack adequate tire labeling, tire pressure gauge, adequate stop engine switch and other safety requirements which could result in injury to consumers.
U.S. CPSC September 9, 2004	Suzuki Recall of Four-Wheel Drive Eiger ATVs There are mislocated welds securing the upper front suspension arm mounting brackets to the frame. The mounting bracket could break off during riding, reducing rider control and resulting in loss of control of the ATV. Loss of control could result in a crash and severe personal injury or death.
U.S. CPSC March 9, 2006	American Suzuki Motor Corp. Recalls All-Terrain Vehicles for Fire Hazard Certain 2005 Eiger model year ATVs were assembled with an improperly manufactured plastic fuel tank. The thin portion of these tanks could develop a fuel leak, posing a fire hazard.
U.S. CPSC September 6, 2007	Ohalee Inc. Recalls Youth All-Terrain Vehicles Due to Mechanical Hazards; Vehicles Could Put Young Riders At Risk of Injury These youth ATVs lack front brakes and a tire pressure gauge, the date of manufacture is not printed on side of the tires, and the front suspension is solid and does not allow for travel.
U.S. CPSC July 10, 2008	Lawn Mowers Recalled by American Honda Motor Corp. Due to Laceration Hazard The lawn mower's rear shield can break off allowing debris to be thrown toward the operator, which poses a laceration hazard to consumers.
U.S. CPSC December 7, 2004	American Suzuki Motor Corporation Recall of 2004 & 2005 Eiger(TM) and Vinson(R) ATVs Recalled ATVs were assembled with an incorrectly sized mounting bolt under the fuel tank. This could result in fuel leakage presenting a fire safety hazard and risk of injury or death.
U.S. CPSC October 22, 2007	ATVs Recalled By KTM North America Due to Brake Failure The rear brake caliper support can crack; this could result in the potential for a loss of the use of the rear brake and subsequently lead to an accident.
U.S. CPSC June 28, 2007	CPSC, Kawasaki Motors Corp. U.S.A. Announce Recall of All-Terrain Vehicles There is a risk of a fuel leak, which poses a fire hazard to consumers.
U.S. CPSC March 29, 2005	Bombardier Recreational Products Inc. and BRP US Inc. Recall of DS650 ATVs The rear axle bearings may have not been sufficiently greased. This may cause a breaking of the bearing which could make the ATV unstable. The operator could lose control of the vehicle which could cause injury to the operator.
U.S. CPSC March 14, 2005	Kawasaki Motors Corp. U.S.A. Recall of Kawasaki Prairie(TM) 700 ATVs The age recommendation warning label is missing. Children under 16 years old riding these adult-size ATVs can suffer serious injury or death.
U.S. CPSC March 10, 2011	American Suzuki Motor Corp. Recalls KingQuad ATVs Due to Fire Hazard Some KingQuad ATV's plastic fuel tanks were improperly manufactured and can develop a fuel leak, posing a fire hazard.
U.S. CPSC July 8, 2010	All Terrain Vehicles Recalled by American Suzuki Motor Corp. Due to Loss of Control Hazard The flame arrester screen can become detached from its mounting ring, preventing the throttle valve from returning to the idle position when the throttle lever is released and causing the rider to lose control of the ATV.
U.S. CPSC October 11, 2005	Bombardier Recreational Products Inc. Recall of All-Terrain Vehicles The drive pulley inner flange could break resulting in the broken flange fragments becoming a projectile. This situation could cause serious injuries or death to the rider or bystanders.
U.S. CPSC February 10, 2009	ATVs Recalled By KTM North America Due to Brake Failure The rear brake caliper support can crack and the front brake operation can experience a loss of pressure, posing a risk of the rider losing braking and steering control and suffering injuries or death.
U.S. CPSC April 29, 2005	American Suzuki Motor Corp. Recall of All-Terrain Vehicles The fuel petcock inserts were made with incorrect material that does not correctly bond the fuel tank and petcock insert, which could allow fuel leakage. If this occurs, a fire hazard with the possibility of injury and property damage could result.
U.S. CPSC November 17, 2005	American Suzuki Motor Corp. Recall of 2005 King Quad All-Terrain Vehicles Use of an improper tie rod adjustment procedure during assembly could lead to separation of the tie rod end housing from the attachment shaft. This could cause the rider to lose control of the ATV and result in injury or death.
U.S. CPSC October 19, 2006	Kawasaki Motors Corp., USA Recalls ATV for Loss of Steering Control Hazard The nuts securing the tie-rod ends to the steering shaft may loosen during operation, causing the operator to lose steering control and crash.
U.S. CPSC December 19, 2007	American Honda Motor Corp. Recalls Lawn Mowers Due to Laceration Hazard The cutting blades could rotate under power when the control lever is released. The lawn mowers do not comply with mandatory federal safety standards for lawn mowers. The spinning blade poses a serious laceration hazard to consumers.
U.S. CPSC July 17, 2008	Log Splitter Engines Recalled By American Honda Motor Co. Due to Fire Hazard The engine's fuel tank can crack and leak, posing a risk of fire or explosion.
U.S. CPSC June 20, 2007	ATVs Recalled by Polaris Industries Inc. Due to Fire Hazard The recalled ATVs may have a loose fuel valve within the fuel tank, which could cause a fuel leak and pose a fire hazard to riders.
U.S. CPSC June 30, 2003	Kawasaki Recall of All-Terrain Vehicles The throttle cable adjuster on the carburetor can loosen during operation, causing it to stick, which can cause the rider to lose control and possibly crash.
U.S. CPSC February 28, 2005	Kawasaki Motors Manufacturing Corp. USA Recall of ATVs On some units, the nut which secures the front upper suspension arm pivot bolt could come loose during vehicle use. Continued use of the vehicle could allow the nut to come off, and the upper suspension A-arm pivot bolt to back partially out. This would result in a loss of steering control, and possibly cause the rider to crash and suffer injury or death.
U.S. CPSC April 13, 2005	Yamaha Motor Corporation, U.S.A. Recall Reminder for ATVs In February 2004, Yamaha announced a voluntary recall of Raptor YFM660R ATVs. Vibration from the engine and driveline during long periods of high rpm usage could cause the rear master cylinder reservoir to agitate resulting in brake fluid aeration and adversely affecting rear brake performance.
U.S. CPSC January 10, 2007	Kawasaki Motors Corp., U.S.A. Recalls 2007 KFX50 and KFX90 All-Terrain Vehicles On some of these units, the handlebar holder, tie-rod adjustment, and tie-rod end nuts may not have been tightened to the proper torque. Operation of the vehicle can cause the nuts to loosen, resulting in a loss of steering control.
U.S. CPSC February 14, 2008	Polaris Industries Expands Recall of ATVs Due to Fire Hazard The ATVs can have defective Electronic Control Modules (ECM) that overheat, posing a fire and burn hazard to riders.
U.S. CPSC June 26, 2008	ATVs Recalled By Kawasaki Due to Loss of Speed Control The throttle can fail to return to the idle position when released or could fail to be at idle on start-up. This could result in loss of vehicle control, posing a risk of serious injury or death to the rider.
U.S. CPSC May 30, 2007	Polaris Recalls Select Hawkeye Model ATVs for Steering Post Failure Hazard The steering posts can break in the area where the handlebar attaches to the steering post. This can result in loss of steering control resulting in a crash and/or serious injury to the operator.
U.S. CPSC March 4, 2008	Polaris Industries Inc. Recalls ATVs Due to Risk of Injury to Riders A retention bolt can come loose causing the rear wheels to lock up, which poses a risk of serious injury to the rider.
U.S. CPSC July 3, 2006	Bombardier Recreational Products Inc. Recalls All-Terrain Vehicles for Fire Hazard The operator could ride with their foot engaging the rear brake without noticing. This can cause the rear brake to overheat and possibly ignite, posing a risk of serious injury or death.
U.S. CPSC January 2, 2008	ATVs Recalled By KYMCO Due to Suspension Failure; Riders Can Lose Control of Vehicle The pivot bolts holding the rear suspension onto the frame can become loose, causing the rear swing arm to detach from the chassis posing a risk of injury or death to the operator.
U.S. CPSC April 14, 2005	American Honda Motor Co. Recall of ATVs The steering rods can separate, causing the driver to lose steering control. This could cause the ATV to crash and pose a risk of serious injury or death.
U.S. CPSC May 13, 2009	Fushin USA Recalls Youth Model ATVs Due to Risk of Injury to Young Riders These ATVs lack front brakes, a tire pressure gauge, and padding to cover the sharp edges on the handlebar assembly, which could pose a risk of injury to young riders.
U.S. CPSC November 8, 2007	American Honda Motor Corp. Recalls Lawn Mowers Due to Fire Hazard Due to a manufacturing defect, a crack can occur in the fuel tank causing a fuel leak. If gasoline leaking from the fuel tank is ignited, a fire or explosion can occur.